Surface Preparation
All surfaces to be coated must be clean, dry and completely free of loose particles, grease, oils, or any substance that would interfere with proper bond. All preparation work including substrate repairs and expansion joints must be completed prior to application. If PUR BRUSHABLE is to be applied over a waterproofing membrane, the membrane should be thoroughly inspected to insure that it has completely set and is devoid of pinholes or interruptions.

Application
Only skilled coating applicators should use this product.

Add the Part A to the Part B while stirring thoroughly with a drill-type stirrer. Mixing must be continued for 3 minutes total. The mix should then be poured back and forth between the 2 component cans twice, then stirred a further minute. The Part C should be stirred into the mixture immediately and stirred for 2 minutes until a uniform paste consistency is achieved. Careful attention to detail will help to produce the desired result in appearance and performance. Once mixed, PUR BRUSHABLE has approximately 40 minutes working time at 70°F and will have developed an initial cure suitable for foot traffic within 24 hours. The floor may be placed into full service within 48 hours.

Limitiations 
Newly applied and coated ROOFAB should not be walked on until it is thoroughly dry.  Do not allow any uncoated areas or sections of ROOFAB to remain exposed.

Maintenance
Any damaged areas can be repaired with ROOFAB to the necessary size and shape to fit the repair.  Next, apply fresh coating (or primer and coating) to the repair area.  Finally, embed the ROOFAB and immediately topcoat the entire area with coating. Allow the repair to fully cure.

Pot Life
40 minutes @ 70°F

Recommended Thickness
20 mils Dry Film Thickness (DFT)

Clean up
Clean tools and equipment with xylene or toluene solvent.

Storage
Store in a dry area and protect from direct sunlight and freezing. Keep container tightly sealed. Shelf life is 2 years from date of manufacture when stored in a factory sealed container between 40ºF (5ºC) and 90ºF (32ºC).

Disposal
Waste disposal must be in accordance with existing federal, state and local environmental control laws. Incineration is the preferred method of disposal.

Read the container label warning and Safety Data Sheet (SDS) for important health and safety information prior to the use of this product.

KEEP AWAY FROM CHILDREN AND PETS

For additional information, contact the Andek Technical Department