POLAROOF SP is a premium quality, water-based, single component waterproofing coating for all standard roofing substrates. Designed for permanent flexibility and toughness, POLAROOF SP provides a finish that is architecturally enhancing, long-lasting, and weatherproof.


Outstanding Features:


Recommended for:

Can be used over metal, tin, aluminum, concrete, wood, foam, composite roofing, slate, tile and others.





Surfaces must be dry, free of dirt, loose debris, oils, greases or any substance that could interfere with bond.   All repairs of damage or defects must be made prior to application.         

POLAROOF SP is applied straight out of the can after 2 minutes of gentle low speed mixing or stirring. Apply the product using brush, roller or spray technique. Apply in two coats to a uniform wet film thickness of about 20 mils per coat to insure complete coverage on the 2nd coat.  Apply the 2nd coat after the 1st coat has set (about 2-4 hours).  For spray applications, use a 30:1 ratio Graco with a #36 tip or similar equipment.  For soft brush or high nap roller application, use light pressure and coat in a cross direction to the 1st coat. For additional information, contact our Technical Department.


Clean up:

Clean tools and equipment with water before the POLAROOF SP dries; after that, solvent cleaning may be necessary.



Do not apply to frozen or saturated surfaces. Do not apply if the temperature is predicted to drop below 35°F within 4 hours after application is completed. Do not apply if rain is forecast within 4 hours of completion of application. Protect Polaroof SP from freezing. In roofing areas where water is likely to pond and be present for more than 1 day after precipitation, it is advisable to topcoat the Polaroof SP with Clearcoat 44 or Clearcoat AQ. Apply the Clearcoat in these areas at a rate of 1 gallon per 200 square feet.



Read the container label warning and Material Safety Data Sheet (MSDS) for important health and safety information prior to the use of this product. 

Keep out of reach of children and pets.



If surface becomes dirty or stained, wash with a mild soapy water solution.  If an area becomes nicked or cut, recoat with POLAROOF SP. 

For additional information, contact the Andek Technical Department.


Technical Data:



Notice: The information presented herein is based on tests and data that Andek Corporation believes to be reliable. It is intended for use by technically qualified personnel at their own discretion and risk. Since conditions of handling and use are beyond our control, we make no warranties, express or implied, and assume no liability in connection with any use of this information. Nothing herein is to be construed as a license to operate or a recommendation to infringe any patent.